Reconnaissance geology and geophysics of the Mercurio structural dome, Chihuahua, Mexico

  • Jorge Aranda Gómez
  • Vsevolod Yutsis División de Geociencias Aplicadas, Instituto Potosino de Investigación Científica y Tecnológica, San Luis Potosí, S.L.P., Mexico.
  • Edgar Juárez-Arriaga Posgrado en Ciencias de la Tierra, Centro de Geociencias, Universidad Nacional Autónoma de México, Querétaro, Qro., Mexico.
  • Carlos Ortega-Obregón Centro de Geociencias, Universidad Nacional Autónoma de México, Campus Juriquilla, 76230 Querétaro, Qro., Mexico.
  • Norma González-Cervantes Posgrado en Ciencias de la Tierra, Centro de Geociencias, Universidad Nacional Autónoma de México, Querétaro, Qro., Mexico.
  • Gabriel Chávez-Cabello Facultad de Ciencias de la Tierra, Universidad Autónoma de Nuevo León, Linares, N.L., Mexico.
  • César Francisco Ramírez-Peña Facultad de Ciencias de la Tierra, Universidad Autónoma de Nuevo León, Linares, N.L., Mexico.
  • David Ernesto Torres-Gaytán División de Geociencias Aplicadas, Instituto Potosino de Investigación Científica y Tecnológica, San Luis Potosí, S.L.P., Mexico.
Keywords: structural dome, forceful injection, geophysical modeling, magma mixing and mingling, Ahuichila Formation, Sierra Madre Occidental, Coahuila Calcareous Platform, Mexico

Abstract

The Mercurio structural dome is a poorly exposed and complex structure located in the transitional region between the Coahuila Calcareous Platform and the San Pedro El Gallo sector of the Sierra Madre Oriental, Mexico. It is located in the State of Chihuahua, close to the limits with Coahuila and Durango, Mexico. The dome is a circular structure, ~16 km in diameter, that can be seen in air-photos, satellite images, and shaded relief maps, but that has a subtle topographic expression on the ground. As seen in the field, the most conspicuous topographic features in the area are several hills with the morphology of volcanic necks that rise up to 250 m above the surrounding terrain. The deformation fringe of the dome is a series of cuesta-like low hills, less than 30 m high, where a poorly lithified volcano-sedimentary succession (litharenites, polymictic conglomerates, and ignimbrites) is almost completely masked by desert pavement, which is mainly constituted by well-rounded calcareous clasts derived from the Mesozoic sedimentary marine rocks and by less abundant Paleogene volcanic rocks exposed in the region. Inside the dome the following units are exposed: 1) the pre-volcanic basement in a NW-trending, upright, open anticline developed in limestone of the Aurora Formation, 2) a series of hills where is exposed a succession of epiclastic and volcanic rocks, which are similar, in age and lithology, to some facies of the Ahuichila Formation, and 3) a NW-trending dike, exposed at Cerro Dinamita, which is interpreted as an offshoot of the buried subvolcanic body that created the dome. The deformation fringe around the buried intrusive has a quaquaversal array in the bedding and forms a simple monocline-like structure in the NE part of the dome. A set of SE- and NW-trending plunging folds forms the SE and SW portions of the dome, respectively. The NW part of the fringe is nearly completely masked by volcanic rocks, but there is a ~W plunging syncline in the area.

Geophysical data show a broad gravimetric high in the region, and there is a distinct aeromagnetic anomaly inside the dome. The morphological expression of the dome lies just east of a NW-trending lineament of gravity and magnetic anomalies, which may be the buried portion of a normal fault shown in geologic maps of the region northwest of the studied area. Another possible cause is an alignment of buried intrusive bodies suggested by the regional aeromagnetic data, a small diorite outcrop south of Sierra El Diablo, and presence of volcanic necks in the northern portion of Sierra Los Alamos. Available geological and geophysical information was used to model a near-surface, irregular intrusive body with variable magnetic susceptibilites. This variation in susceptibilities is consistent with observed differences in rock composition in the exposed volcanic rocks and with evidence that the structure was formed by a bimodal (andesite-rhyolite) magmatic system where mixing/mingling occurred.

As a whole, the set of structures is interpreted as a dome formed by forceful magma injection into a previously folded Paleogene volcano-sedimentary succession. U-Pb zircon ages were used to bracket the age of the deformation pulses registered in the rocks. Litharenites from the deformed volcano-sedimentary succession yielded an Ypresian zircon age of ~51 Ma. A tilted, lithic-rich ignimbrite collected near the top of the exposed volcano-sedimentary succession has mean age of 46.4 +0.8/-1.6 Ma, and the Cerro Dinamita dike has a mean age of 29.37 ± 0.24 Ma. Thus, the youngest pulse of Laramide deformation in the area is younger than ~46 Ma and the re-folding, associated with emplacement of the dome occurred at ~29 Ma.

Detrital zircon U-Pb ages from Mercurio sandstones suggest dominant sediment sources from plutonic and/or volcanic rocks exposed along western Mexico. Likely subordinate sources are Mesozoic sedimentary rocks in northern and central Mexico. Distribution of detrital zircon U-Pb ages in the studied samples is similar to that documented in sandstones of the Difunta Group at the Parras and La Popa basins, except that older grains (>1.0 Ga), documented in the clastic rocks of these basins, are scarce in the sandstones of the Mercurio area.

Published
2019-11-30
Section
Regular Papers